Install Remote Control Battery; Turn On - Philips CEM2000 - annexe 1 User Manual

8
Reconnect the negative terminal of the
car battery.
Attach the front panel
1
Attach the trim plate.
2
Insert the right side of the panel in the
chassis until it is correctly engaged.
3
Press the left side of the panel until the
mechanism locks it into place.
14 EN

Install remote control battery

Caution
•
Risk of explosion! Keep batteries away from
heat, sunshine or fire. Never discard batteries
in fire.
•
Risk of decreased battery life! Never mix
different brands or types of batteries.
•
Risk of product damage! When the remote
control is not used for long periods, remove
the batteries.
•
Perchlorate Material - special handling may
apply. See www.dtsc.ca.gov/hazardouswaste/
perchlorate.
For first-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2025 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.

Turn on

1
Press to turn on the unit.
• To turn off the unit, press
3 seconds.
for over