Before Requesting Service - Panasonic Omnivision PV-C1322 Operating Instructions Manual

Before Requesting Service |
Check the following points once again if you are having trouble with your unit.
Power Correction
No power... * Completely insert Power Plug into an AC outlet.
* Set POWER button to ON.
Nifelericels Correction
No picture or sound... ae ee ee ee eee , iS Correctly set. (P. 8)
Completely insert Power Plug into an AC outlet.
Set POWER button to ON.
Poor picture with normal sound... Adjust BRIGHTNESS, SHARPNESS, and PICTURE controls in
the SET UP TV menu. {P. 15)
Poor sound with normal picture... Adjust VOLUME control. (P. 14)
Poor TV reception... Adjust SHARPNESS and PICTURE controls in the SET UP TV menu. (P. 15)
No color or poor color... Adjust TINT and COLOR conirols in the SET UP TV menu. (P. 15)
Ghost (multiple) images... Install a directional antenna.
TV programs cannot be watched...| * Make sure the selected channel is in unit's memory. (P. 10, 11}
Channel cannot be selected... Only the channel being recorded can be viewed on this unit.
Correction
TV program cannot be ¢ Make sure your antenna system (TV or CABLE), is correctly set. (P. 8)
recorded... Make sure cassette record tab is intact. (P.3)
Check that clock is set to current time and date.
Timer recording cannot be Make sure DSS/CABLE box (if used) is teft on and tuned to
performed... channel to be recorded.
* Set recording Start/Stop times correctly, (P, 22-23)
¢ Timer recording may not be performed or continued if a power
interruption of more than 1 minute occurs before or during a Timer
ecg even after power is restored.
No playback picture, or the playback] * Adjust TRACKING control in either direction. (P. 4)
picture fs noisy or contains sireaks...| * Try Head Cleaning. (P. 4)
VCR cannot be controlled... Make sure VCR LOCK is set to off. (P. 27)
Make sure unit is not in a Timer Record operation.
at =11i fe) (=m OXelal tae) Correction
Unit cannot be controlled... Aim remote at remote sensor on unit (P. 7) so that signal is
unobstructed.
Inspect the rernote batteries. (P. 3)
¢« Make sure VCR LOCK is set to off. (P. 27)
* Exposing unit remote sensor to direct fluorescent or outdoor light
may cause signal interference.
ACTION, PROG and FM/TV Check remote batteries.
buttons cannot be selected...
Miscellaneous Correction
Vii cassette cannot be inserted... * Insert the cassette window side up; record tab facing you.
cassette cannot be removed...| « Completely insert Power Plug into an AC outlet.
Tape cannot be ejected or inserted... . Try ejecting or inserting the tape again after tuming POWER off, then back on.
Video cassette ejects when a * Make sure cassette record tab is intact. (P. 3)
recording is started, or the power
: tumed off for timer recording...
In Stop mode, the VCR motor * To enable Quick Play mechanism, the VCR cylinder will rotate for
{CYLINDER) continues to rotate... about 3 minutes. This reduces response time from Stop to Play
mode and from Piay to Rewind Search mode.
VCR cannot be controlled... * Make sure VCR LOCK is set to off. (P. 27)
If you cannot resolve the problem, please call the Customer Satisfaction Center for
product assistance at 1-800-211-PANA(7262).
To locate an authorized servicenter call toll free 1-800-211-PANA(7262)
or send e-mail to : consumerproducts @ panasonic.com.
WYel Prey (0) Blavey Wey
33