Was Opc Ration Oiaisaisassscccsesuctieevecovashasseuactlicceicccvatertcatsesssezstecduees 24 - Panasonic Omnivision PV-C1322 Operating Instructions Manual

Combination vcr
Hide thumbs Also See for Omnivision PV-C1322:
Table of Contents

Advertisement

Tape Operation
Search System is ...
Each time a recording is made, an invisible index mark is placed on the tape.
When timer recordings are made, program index and information are also included.
These index marks can be used to access or scan recordings.
Tale(=> @bet-ts1 oda]
Go directly to the desired recording.
1
INDEX SEARCH
Press SEARCH*
ENTER INDEX NUMBEA:1
in Playback or
USING 1-9KEYS
Stop mode to
Soe Bey | SEARCH ecto
NEXT:SEARCH
SEARCH
screen,
walls
and then press
NUMBER Keysto
Select the
recording number.
* To calculate number,
see below.
Press FF or REW
to start search.
Play begins at
search end. To
search forward or
back 1 index,
press FF or REW
while screen left in
displayed (10 sec.).
FORWARD SEARCH: FF
REVERSE
SEARCH: REW
i To calculate the Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
NNN
pt] 2 fata fst 6 [7
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
fe
N
pi | 2 fs fatst
¢ {7
NOTE: + indicates start points of each recording.
* Make each entry within 10 seconds, or the Index
Search mode will be canceled.
* If Index Search is started very close to an index
mark, that index mark may not be counted in the
search.
24
Teen
ee
tiesie oz)
or send e1nail to : consumerproducts @panasonic.com
Program End Search
Locates end point of recording for continuity.
Press SEARCH twice in Playback
or Stop mode to display
PROGRAM END SEARCH screen
y) -oeosie
SEARCH
START:FF
Press FF to
start search.
EXIT : SEARCH
Example of Program End Search operation.
Fig.1
PLAYBACK DIRECTION ——»
Lp Program 1
WRIT "Proaram 2 or BLANK T
Press SEARCH button
INEndPoint]
FF
Fig.2
[Preoram it ]]{ ¢BLANK |[s[[Program
2 ]ff BLANK |
Press SEARCH button
{ena Point]
FF
Fig.3 tfsearch exceeds a few seconds in BLANK area.
Press SEARCH button
Foot
an
"di Proorem |
Upon locating end point...
The unit searches slightly past end point,
reverse searches, and plays the last few
seconds of the program, then stops.
[Ly Femem retanro TfP Program 2 GAN]
Press SEARCH button
——_seaat
\ Notes
If Program End Search is started very
close to an index mark, that mark may be
skipped over.
To cancel, press PLAY or STOP.
Sd

Advertisement

Table of Contents
loading

Table of Contents