Panasonic Omnivision PV-C1322 Operating Instructions Manual page 26

Tape Operation (continued)
Zero Search
To quickly return to a specific tape counter location.
Press DISPLAY during playback to
display the Counter.
Press COUNTER
0: | RESET at the
desired position to
reset to ^0:00:00."
2
Continue playback, rewind, or
fast forward.
4 Press STOP.
o
Press CM/ZERO
in stop mode to
start ZERO
SEARCH.
¢ Y: Presentposition mark
V: Zero position mark
* Unit goes into FF or REW mode and stops at
the last point the Counter was set to 0:00:00.
cap
* Ifa blank portion exists on the tape, and
depending on the position of the V mark, the
V mark display may be out of position.
Commercial Skip
By pressing the CM/ZERO button in Playback mode
you can skip over 1 to 3 minutes of recorded tape in
just a few seconds.
Press CM/ZERO repeatedly to
select skip time in Play mode.
* Noindication appears.
OFF
y
1st Press —*1 min Skip
2nd Press —+2 min Skip
3rd Press — 3 min Skip
20 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Repeat Play
Set to see a recording over and over.
Press ACTION to display
MAIN MENU.
1) Press AV >
to select "VCR."
2) Press
ACTION to
display SET
UP VCR
screen.
1)Press AY to
select
"REPEAT
PLAY."
2)Press b to
set REPEAT
PLAY "ON" or
"O FF."
Press ACTION twice
to end setup.
«Hu
* Playback repeats when tape end is reached or
unrecorded portion over 30 seconds is detected.
* During playback, you may also press PLAY/
REPEAT repeatedly on the unit to select
REPEAT "ON" or "OFF."
SET UP VCR
REPEAT PLAY : OFF
TIMER. PROGRAMMING
SELECT:A Y
"d
END :ACTHON