Panasonic Omnivision PV-C1322 Operating Instructions Manual page 23

Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cance! the Timer Recording.
* Any future daily or weekly recordings
will be performed as programmed.
ADD/DLT
SELECT/SET
A :CH UP
y ¡CH DOWN
» :VOL UP
<4 VOL DOWN
oat
PROG
STOP
Review, Replace or Clear Program
Contents : (Recording is not in progress)
1 Repeat steps 1 and 2 on page 22.
Press AV to select
the desired program.
CANCEL : ADD/DLT
SELECT 1-8:4 Y
Ro
: PROG/ACT FON
3 To Replace program...
1) Press P to display.
START STOP CH
B SAT 9:00P 12:004 v 2) Press AV to select
CATEGORY: MOVIE and press «or»
SELECT START DATE to set new program
SELECT
END TS contents.
3) Press PROG (or
ACTION).
To Clear program...
Press ADD/DLT.
P DT START STOP CH SPD
1
SELECT 1-8:4 v
ENTER :»
END : PROG/ ACT I ON
Press PROG twice (or ACTION)
to exit this mode.
4
5
* 2 minutes before Timer recording is performed,
"PLEASE PREPARE FOR TIMER REC" appears and/
or the PROG TIMER Indicator flashes. Be sure a
cassette with record tab is loaded and the unit is in
Stop mode.
If the start times of two programs overlap, the lower
numbered program will have priority.
If the start time for a Timer Recording comes up during
a normal recording or One Touch Recording (page 12),
the Timer Recording will not be performed.
If there is a power interruption of more than one minute,
the recording may not be performed or continued.
If "INCOMPLETE" appears after all items have been
set, check all entries and make necessary corrections.
23
e