Aiwa XH-A1000 Operating Instructions Manual page 25

* Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
¢ Up to 30 tracks can be programmed from any of the inserted
discs.
« "FULL is displayed if you attempt to programme more than 30
tracks.
About cassette tapes
¢ To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
lL
Type II tape Tab for side A\
detection
slot
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to cover
the Type II tape detection slot.)
* 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
¢ Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape
recorded with the DOLBY NR system, turn on the DOLBY
NR system:
The DOLBY PRO LOGIC feature and the centre and surround A@
speakers (standard) assure full-scale home theater sound. When :
playing back laser discs or video software that have been
recorded in Dolby Surround, astonishingly realistic sound
surrounds the listener to create a new level of audio/visual
entertainment.
Independent control of the five sound channels allows the listener
to enjoy the same type of sound reproduction experienced in
movie theaters. Voices are reproduced in the front and centre
sound field, while ambient sounds like cars and crowds are
reproduced on all sides of the listener for an incredibly lifelike
audio/video experience. Please read the following carefully to
"tune" the system's output to match the characteristics of your
listening space.
Check the following:
¢ Before using the DOLBY PRO LOGIC, adjust the proper
balance of speaker sound levels.
¢ Make sure the supplied speakers are properly connected and
positioned (see page 5).
¢ Make sure the TV set and video unit are properly connected
(see page 7).
«Make sure the laser disc, video tape, etc., support
DO Bousy surrouno) |
* MANUAL
SELECT
Oo
S I ) PROLOGIC
pat << >
The unit is equipped with a built-in test signal generator called a
noise sequencer for easy balance adjustment of all 5 channels.
The sequencer outputs a noise signal that "travels" from channel
to channel, enabling the simple adjustment of sound level to
achieve, at the listening position, the same apparent loudness
from each channel.
1 Press DOLBY PRO LOGIC to select NORMAL.
"NORMAL is displayed.
If "PHANTOM" or "3 STEREO" is displayed, press DOLBY
PRO LOGIC repeatedly until "NORMAL is selected.
eo