Avantco Equipment 177EMBS65SS Operating Instructions

Meat Saw
#177EMBS65SS
Before Installation: Operators and handlers of this equipment should wear cut-resistant gloves to prevent injury.

Installation

1. A team lift is required to carefully
remove the Avantco Meat Saw
from the package.
2. Place the unit on a stable,
level surface.
- Rubber feet on the equipment's
bottom can be adjusted accordingly
if a level surface is not available.
3. Ensure the supplied voltage and
power match the voltage and power
requirements on the unit's label.
4. The saw comes preassembled with a
4 TPI saw blade.
- The blade should be changed before
Operation if necessary, according to
food product.
5. Open the upper and lower
cavity door.
6. Install blade in the upper and lower
cavity over both wheels.
a. The blade must be parallel with
the edge of the block for optimal use.
b. Ensure blade is facing the right direction – towards the front – with the teeth edge of the blade flush
with the edge of the wheel.
7. Close the machine's door and tighten the hand nut on the side of the machine.
8. Turn the tension knob counterclockwise until it clicks.
9. To start the machine, press the green button. Ensure the machine is working properly before adding food
product.
- The blade should run clockwise when operating properly.
10. To stop the machine, press the red button to stop the saw. Then, unplug the machine.
www.AvantcoEquipment.com
Operating Instructions
Electric
Line
02/2024
Tension
Knob
On/Off
Top Wheel
Scraper
Adjust
Setting
Lower
Wheel