Advertisement
PART 3:
Installation
Registration
Card:
If
you
have
not
already
done
so,
please
fill
out
the
Registration Card fully and mail it to the factory. ( See Preface.)
Unpacking And Initial Inspection:
You
are now
ready
to
proceed
with
unpacking
and installation of your OPTIMOD-TV.
Sometime during the life of your OPTIMOD-TV, you may wish to re- ship it. Since
it
is expensive
and heavy,
it
is advisable to ship it only in the original
packing
materials which have been carefully designed to protect
it. For this reason, it is
wise to mentally note the
method of packing and to save
all packing materials.
Sage
advice
for
repacking
and
reshipping
your
unit
is
contained
at
the
end
of
Appendix F.
Various items are packed with OPTIMOD-TV:
(1)
Line Cord
(4)
10-32x3/4" Rack Screws
(1)
3- wire AC Adapter
(1)
This Operating Manual
(1)
5/64" Allen Wrench ( for front panel screws)
(2)
Keys For Access Door
(2)
620
ohm + 5%
1/4
watt
carbon
film
resistors ( for
input
termination
if
required)
Physical Examination: Perform
a general
inspection of the perimeter
of the unit
to check for obvious damage.
DAMAGE
CLAIMS
MUST
BE
MADE
BY
YOU
AGAINST
THE
CARRIER
IMMEDIATELY UPON DISCOVERY. Save packing and other evidence of damage for
the carrier's inspector.
Set
the
unit on a flat, soft surface. Remove the three hex- socket screws at
the
top of the front panel using the wrench provided. The front panel, which is hinged
at
the bottom, will then tilt downward and reveal the interior. Look
for IC's or
other loose parts which may have fallen out during shipment.
Remove
the
subpanel
through
which
the
controls
protrude
by
twisting
the
four
DZUS fasteners 1/4 turn counterclockwise. Tilt the panel to remove it. This reveals
the " card cage".
Various components are mounted in sockets for servicing convenience. It is possible
that a component could be dislodged by heavy shocks in shipment.
Starting
at
the left, using the card ejector tabs, carefully remove
each card
in
turn, examine it, and replace it. Make sure that all components are properly seated
in their sockets. Check with particular care to make sure that none of the IC's are
held in their sockets by one row of leads only.
Power Considerations: OPTIMOD-TV
will
operate
on
115/230V + 15%
50-60Hz
AC
power. Due to the conservative design of the power supply, it should also operate
properly on 100 or 208 volt service.
3-1
Advertisement
