Cub Cadet 524 SWE Operator's Manual page 7

3. 3. Finish securing chute control assembly to chute support Finish securing chute control assembly to chute support
bracket with wing nut and hex screw removed earlier. bracket with wing nut and hex screw removed earlier.
See See Fig. 3-4. See See Fig. 3-4.
Figure 3-4 Figure 3-4
4. Check that all cables are properly routed through the cable
guide on top of the engine. See Fig. 3-5.
4. Check that all cables are properly routed through the cable
guide on top of the engine. See Fig. 3-5.
Figure 3-5 Figure 3-5
Set-Up Set-Up
3. 3. Finish securing chute control assembly to chute support Finish securing chute control assembly to chute support
bracket with wing nut and hex screw removed earlier. bracket with wing nut and hex screw removed earlier.
Shear Pins Shear Pins
See See Fig. 3-4. See See Fig. 3-4.
4. 4. Check that all cables are properly routed through the cable Check that all cables are properly routed through the cable
A pair of replacement auger shear pins and bow tie cotter pins A pair of replacement auger shear pins and bow tie cotter pins
guide on top of the engine. See Fig. 3-5. guide on top of the engine. See Fig. 3-5.
are included with your snow thrower. Store them in your snow are included with your snow thrower. Store them in your snow
thrower's dash panel until needed. See Fig. 3-5. thrower's dash panel until needed. See Fig. 3-5.
Figure 3-6 Figure 3-6
Chute Clean-Out Tool Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Fig. 3-7. the cable tie before operating the snow thrower. See Fig. 3-7.
Figure 3-7 Figure 3-7
s
ectiOn
Chute Clean-out Tool
3 — a & s -u
sseMbly et p
7