Operator Safety While Using Internal Combustion Engines; Service Safety - NUequipment CRP40 Series Owner's Manual

1.2 Operator Safety while using Internal Combustion Engines

Do not smoke when refueling the engine or during any other fuel handling operation.

Do not run the engine near sparks or open flames.

Do not start the engine if fuel has spilled or a fuel odor is present. Move the machine

away from the spill and wipe the machine dry before starting.
Do not refuel a hot or running engine.

Do not refuel the engine near sparks or open flames.

Do not spill fuel when refueling the engine.

Do not touch the engine or muffler while the engine is on or immediately after it has

been turned off. These areas get hot and may cause burns.
If fuel is spilled during refueling, wipe it off from the engine immediately and discard the

rag in a safe place. Do not operate the unit if fuel or oil leaks exist-repair immediately.
NEVER operate this equipment in an explosive atmosphere.

NEVER operate any gas powered equipment in a poorly ventilated or enclosed area.

NEVER perform any work on the unit while it is running. Before working on it, stop the

engine and disconnect the spark plug wire to prevent accidental starting.
Avoid prolonged breathing of exhaust gases. You may be hurt by harmful exhausted

gases.
Avoid contact with hot exhaust systems and engine parts.

Allow engine to cool before performing any repairs or service.

ALWAYS transport and handle fuel only when contained in approved safety containers.

ALWAYS keep the area around the muffler free of debris such as leaves, paper, cartons,

etc. A hot muffler could ignite the debris and start a fire.

1.3 Service Safety

Read and understand the instructions contained in the manual delivered with the

machine before servicing or maintaining
Familiarize yourself with the location and proper use of all controls and safety devices

before servicing or maintaining.
Contact local dealer for additional training if necessary.

Do not allow improperly trained people to service or maintain the machine. Personnel

servicing or maintaining the machine must be familiar with the associated potential
risks and hazards.
Do not attempt to clean or service the machine while it is running. Rotating parts can

cause severe injury.
Do not remove blades while the machine is hanging overhead.

Disconnect the spark plug on machines equipped with gasoline engines, before

servicing, to avoid accidental start-up.
When replacement parts are required for this machine, use only our replacement parts

or those parts equivalent to the original in all types of specifications, such as physical
dimensions, type, strength, and material.
6