Page 1
Polaris Ranger 1500 Self-Canceling Turn Signal System Thank you for purchasing XTC Power Products Automatic Self -Canceling Turn Signal System. Our Easy Install Turn Signal System is unique from the other kits on the market. This kit is from our Plug & Play ™ product line, no wires to cut, no crimping with only power, ground and plugs into the OEM Taillight Harness, utilizing the brake lights as Brake and Turn Signals.
Page 2
WARNING! Make sure to keep the harness away from any hot or moving parts. 2. Remove the two rear taillights. Under the rear dump bed on the passenger side frame, following the rear factory wire harness, run the connector with the green wire over to the passenger taillight, plug into the car harness and then into the taillight.
Page 3
6. The Switch Harness has a 10-pin connector on it. Run the connector from under the dash through the rubber gromet to the ATS control module and plug in. 7. Mount Billet Turn Handle – Run the billet handle to the steering column, using the turn lever as a template, position the lever and mark the two mounting holes.
Page 4
480-558-8588 www.xtcpowerproducts.com *Disclaimer: This kit is intended for off road use only and XTC Motorsports claims no responsibility for it use. It is up to the purchaser to make sure it complies with all Federal, State and Local laws. R1...