XTC RZR-SW-USB-2B Manual

Panel Mount USB Power Port
Thank you for purchasing our RZR-SW-USB-2B Plug & Play USB Panel Port. Please read the instructions fully to
familiarize yourself with the components before starting the install.
1. Remove Hood and Dash Cover
2. Remove the USB from the power wire.
3. Attach the red Fused wire to the left Busbar Accessory Post and the ground wire to the ground post.
Remove the Torx screw and mount the fuse holder as shown above.
4. Cut one of the dash switch cut outs. Make sure there is room behind the dash for the adapter. Run the wires through
rubber grommet on the fire wall and through the switch cut out to the USB adapter
5. Attach the Red wire to the + input and the black wire to the - on the adapter