Toro 74760 Operator's Manual page 43

3. Measure from the tip of the blade to the flat
surface here.
Figure 47
1. Blade, in position for measuring
2. Level surface
3. Measured distance between blade and surface (A)
4. Rotate the same blade 180 degrees so that
the opposing cutting edge is now in the same
position.
Figure 48
1. Blade, side previously measured
2. Measurement position used previously
3. Opposing side of blade being moved into measurement
position
5. Measure from the tip of the blade to the flat
surface here. The variance should be no more
than 1/8 inch (3mm).
1. Opposing blade edge, in position for measuring
g014973
2. Level surface
3. Second measured distance between blade and surface (B)
WARNING
A blade that is bent or damaged could
break apart and could seriously injure or
kill you or bystanders.
• Always replace bent or damaged
blade with a new blade.
• Never file or create sharp notches in
the edges or surfaces of blade.
A. If the difference between A and B is greater
than 1/8 inch (3mm) replace the blade with
a new blade. Refer to Removing the Blades
and Installing the Blades.
g014974
Note:
one and the dimension obtained continues
to exceed 1/8 inch (3mm), the blade spindle
could be bent. Contact an Authorized Toro
Dealer for service.
B. If the variance is within constraints, move to
the next blade..
Repeat this procedure on each blade.
43
Figure 49
If a bent blade is replaced with a new
g014973