Yamaha RX-V1065 Owner's Manual page 70

Problem
The picture is The video software is copy-protected.
disturbed.
No sound. Incorrect input or output cable
connections.
No appropriate input source has been
selected.
Speaker connections are not secure.
The volume is turned down or muted.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
The HDMI components connected to this
unit do not support the HDCP copy
protection standards.
"Audio Output" in "HDMI" is set to
"TV".
A proper audio decoder is not selected.
Only the center
When a monaural source sound field
speaker outputs program is applied, sound of all channels
substantial sound. are output from the center speaker for
some surround decoders.
The playback component or speakers are
not connected properly.
No sound is output Output from that speaker is disabled.
from a specific
speaker.
The volume of that speaker is set to
minimum in "Speaker Setup" in the
"Setup" menu.
This unit is in the straight decode mode.
Sound may not be output from certain
channels depending on input sources or
sound field programs.
The speaker is malfunction.
Cause
Connect the cables properly. If the problem persists,
the cables may be defective.
Rotate the RINPUT selector (or press dInput
selection key) to select the desired input source.
Secure the connections.
Turn up the volume.
Display "Signal Info" in the Option menu and check
the input signal format.
If "No Signal" is displayed, check if the playback
component is properly connected to this unit (or a
proper input source is selected).
If "___" is displayed, the input signal in that format
cannot be reproduced by this unit.
Connect HDMI components that support the HDCP
copy protection standards.
Set "Audio Output" (Function Setup → HDMI →
Audio Output) to the other setting.
Display the Option menu and set "Decoder Mode" to
"Auto".
Try another sound field program.
Connect the cables properly. If the problem persists,
the cables may be defective.
Check the Speaker indicators on the front panel
display. If the corresponding indicator is turned off,
try the following.
1) Change the input source to another one.
2) With the selected sound field program, sound is not
output from that speaker. Select another sound field
program.
3) "None" may have been selected for that speaker on
this unit. Display "Speaker Setup" in the "Setup"
menu and enables output of that speaker.
Display "Speaker Setup" in the "Setup" menu and
adjust the volume (Manual Setup → Speaker Level).
Press OSTRAIGHT (or gSTRAIGHT) to turn
off the straight decode mode.
Try another sound field program.
Check the speaker indicators on the front panel
display. If the corresponding indicator lights up,
connect another speaker and check if sound is output.
If sound is not output, this unit may be malfunction.
Troubleshooting
Remedy
See
page
15
22
11
22
—
81
58
47
25
12, 15
6, 22, 25,
55
57
28
25
—
67
En