Using Multi-Zone Configuration; Connecting Zone2 - Yamaha RX-V1065 Owner's Manual

This unit allows you to configure a multi-zone audio system. This feature allows you to set this unit to reproduce separate
input sources in the main zone and the second zone (Zone2). You can control this unit from the second zone using the
supplied remote control.
Only analog signal can be sent to the second zone. If you want to output sounds to Zone2, connect an external
component to the AV5-6, AUDIO1-2 or VIDEO AUX (AUDIO) jacks (by analog connection). For example, if you
want to output sound from an HDMI DVD player to the second zone, you must connect the HDMI DVD player to this
unit by both HDMI and analog connections.

Connecting Zone2

You need the following additional equipment to use the
multi-zone functions of this unit:
• An infrared signal receiver in the second zone.
• An infrared signal emitter in the main zone. This emitter
transmits infrared signals from the remote control to a
CD player or a DVD player, etc. in the main zone via
the infrared signal receiver in the second zone.
• An amplifier and speakers in the second zone.
y
• Since there are many possible ways to connect and use this unit in a
multi-zone configuration, we recommend that you consult with your
nearest authorized Yamaha dealer or service center about the Zone2
connections that best meet your requirements.
• Some Yamaha models can be directly connected to the REMOTE jacks
of this unit. You may not need use an infrared signal emitter for these
products. Up to 6 components can be connected using monaural analog
mini cables or via an IR flashers. For details about connections, see
"Transmitting/receiving remote control signals" (page 17).
Using an external amplifier
Connect an amplifier/receiver in the second zone and
other components to this unit as follows.
Main zone
DVD player (etc.)
This unit
Infrared signal
emitter
From the REMOTE OUT jack
Note
• To avoid unexpected noise, DO NOT USE the Zone2 feature with CDs
encoded in DTS.

Using multi-zone configuration

From the ZONE2 OUT jacks
Amplifier
Second zone
(Zone2)
Remote control
Infrared signal
receiver
To the REMOTE IN jack
Using the internal amplifier of this unit
Important safety notice
The EXTRA SP terminals of this unit should not be
connected to a Passive Loudspeaker Selector Box or
more than one loudspeaker per channel.
Connection to a Passive Loudspeaker Selector Box or
multiple speakers per channel could create an
abnormally low impedance load resulting in amplifier
damage. See this owner's manual for correct usage.
Compliance with minimum speaker impedance
information for all channels must be maintained at all
times. This information is found on the back panel of
your unit.
Connect the speakers in the second zone to the EXTRA
SP terminals and then set "Extra Speaker Assignment" to
"Zone2" (page 56).
Second zone
(Zone2)
y
• You can use the speakers connected to EXTRA SP terminals as the front
speaker system of another zone.
• When you use the internal amplifiers for the Zone2 speakers, you can
adjust the volume level and set the initial volume and maximum volume
of the Zone2 speakers (page 60).
EXTRA SP ZONE2/PRESENCE
This unit
Main zone
61
En