Yamaha RX-V10MKII Owner's Manual page 17

9
RDS MODE/FREQ button
<
Europe and U.K. models only
When an RDS station is received, pressing this button changes
the display mode into the PS mode, PTY mode, RT mode, and
frequency display in turn.
0
PTY SEEK MODE button
<
Europe and U.K. models only
Turns the unit into the PTY SEEK mode.
A
PTY SEEK START button
<
Europe and U.K. models only
Begins searching for a station after the desired program type is
selected in the PTY SEEK mode.
B
EON button
<
Europe and U.K. models only
Selects the desired program type (NEWS, INFO, AFFAIRS,
SPORT) when you want to call a radio program of the program
type automatically.
C
FM/AM button
Press this button to switch the reception band between FM and
AM.
D
A/B/C/D/E button
Press this button to select a group (A to E) of preset stations.
E
TUNING MODE (AUTO/MAN'L MONO) button
Press this button to switch the tuning mode between automatic
and manual. To select the automatic tuning mode, press this
button so that the "AUTO" indicator is illuminated on the
display. To select the manual tuning mode, press this button so
that the "AUTO" indicator is not illuminated.
F
MEMORY (MAN'L/AUTO FM) button
Use this button to enter a station to memory. Refer to the
section "Manual preset tuning" on page 28 for details.
Hold down this button for more than 3 seconds to start
automatic preset tuning. Refer to page 29 for details.
>
>
>
>
G
PRESET STATIONS/TUNING button
This button is used for the PRESET STATIONS function when
"PRESET" is illuminated on the display, and the TUNING
function when "PRESET" is not illuminated. The following
explains these functions in detail.
PRESET STATIONS :
Selects a preset station number (from 1 to 8).
Press the side to select a higher preset station number.
Press the side to select a lower preset station number.
TUNING :
Used for tuning. Press the
frequency, and press the
frequency.
H
CENTER MODE button
Selects a center channel output mode (NORMAL, WIDE or
PHANTOM). (For details, refer to page 22.)
I
PROGRAM button
When this button is repeatedly pressed, the built-in digital
sound field processor turns on, then the selected DSP program
changes to another program one by one, then the digital sound
field processor turns off, and repeated.
J
KEY MODE/EDIT button
Press this button to alternately illuminate and turn off
"PRESET" on the display panel. This button switches the
function of the PRESET STATIONS/TUNING button.
This button is also used to exchange the places of two preset
stations with each other.
K
Tone controls
These controls are effective only for the sound from the main
speakers.
BASS
Used to increase or decrease the low frequency response.
The 0 position produces flat response.
TREBLE
Used to increase or decrease the high frequency response.
The 0 position produces flat response.
L
BALANCE control
This knob controls the sound from the main speakers only.
The balance of the output volume to the left and right main
speakers can be adjusted to compensate for sound imbalances
caused by the speaker location or listening room conditions.
side to tune in to a higher
side to tune in to a lower
17