KitchenAid 7KSM150 Manual page 9

Hide thumbs Also See for 7KSM150:
Table of Contents

Advertisement

Available languages

Available languages

PRODUCT SAFETY
ELECTRICAL REQUIREMENTS
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
Residence mains:
The mains wires must be of copper with a
minimum cross-section per ABNT
(NBR-5410).
To protect this appliance and the mains
against overloading, this appliance must be
connected to a circuit that is protected with
a thermomagnetic circuit breaker.
If the household circuit does not include
a circuit breaker, contact an electrician to
have one installed.
Electric outlet:
For your safety and to avoid damage to
your product, it is very important that your
product is earthed correctly.
Your appliance power cord features a
hexagon-shaped plug, 10A, per ABNT
(NBR 14136).
Your residence electrical installation must
have a suitable electric outlet for this type
of plug. If not, it is your responsibility to
have one installed by a qualified electrician.
W11647986A.indb 9
W11647986A.indb 9
Use appropriate outlet type for your
appliance plug, as shown below:
Before operating this
appliance, make sure
the main voltage at
the installation site is
the same as indicated
on product technical
data label.
This information is also included on the
label attached to your appliance's cord
near the plug.
IMPORTANT:
• If it is necessary to convert your
127 V appliance to 220 V, use a 1.0 KVA
stabiliser.
• If it is necessary to convert your 220V
appliance to 127 V, use a 1.0 KVA
stabiliser.
• Never plug your appliance into
multiplug adapters with another
appliance in the same socket. Do
not use an extension cord. This type
of connection may cause electrical
overload in the mains, and can damage
the appliance and could cause a fire. The
appliance should be plugged into its
own outlet.
• In case of oscillation
in mains voltage,
install an automatic
voltage stabiliser
with minimum
rating of 1500
Watts between the
appliance and the socket.
• If the cord of this appliance is damaged,
it must be replaced. Contact your
nearest authorised KitchenAid Customer
Care Centre.
9
3/14/2023 6:20:29 PM
3/14/2023 6:20:29 PM

Advertisement

Table of Contents
loading

Table of Contents