Table of Contents
Advertisement
Available languages
Available languages
PARTS AND FEATURES
OFF
To attach Bowl
•
Be sure Speed Control Lever is
off (0).
•
Tilt Motor Head back.
•
Place bowl on Bowl Clamping Plate.
•
Turn bowl gently in clockwise
direction (see picture above).
•
Place Pouring Shield* on bowl.
To remove Bowl
•
Turn Speed Control Lever to off (0).
•
Tilt Motor Head back.
•
Turn bowl in counterclockwise
direction.
To attach Flat Beater, Wire Whip or
Dough Hook
•
Turn Speed Control Lever to off (0)
and unplug.
•
Raise Motor Head.
•
Slip beater onto Beater Shaft and
press upward as far as possible.
•
Turn beater to right, hooking
beater over pin on shaft.
To remove Flat Beater, Wire Whip or
Dough Hook
•
Turn Speed Control Lever to off (0)
and unplug.
•
Raise Motor Head.
•
Press beater upward as far as
possible and turn left.
•
Pull beater from Beater Shaft.
*If Pouring Shield is included.
W11647986A.indb 3
W11647986A.indb 3
ON
To lock Motor Head in raised position
•
Push Locking Lever into UNLOCK
position and hold.
•
Tilt Motor Mead back.
•
Move Locking Lever into LOCK
position.
To lock Motor head in operating position
•
Push Locking Lever into UNLOCK
position and hold.
•
Lower Motor Head until it is completely
down into operating position.
•
Move locking lever into LOCK position.
•
Before mixing, test Motor Head lock by
attempting to raise head.
NOTE: Motor Head should always be kept
in LOCK position when using mixer.
To operate control speed
•
Speed Control Lever should always be
set on lowest speed for starting, then
gradually moved to desired higher
speed to avoid splashing ingredients
out of bowl. See "Speed Control
Guide" section.
3
3/14/2023 6:20:28 PM
3/14/2023 6:20:28 PM
Advertisement
Table of Contents
