Table of Contents
Advertisement
Parts and MIDI Channels
GS Mode
In this mode you select which 'Part(s) on your
keyboard or sound module will receive tuning data
(in the form of Exclusive messages) from the ASC-10.
O Press [MIDI].
The LED on the [MIDI] button will begin to flash and
one or more of the 16 Number buttons (one for each
Part) will light. [The button(s) which light(s) will reflect
the previous setting(s).] The Number button(s) which
light(s) corresponds to the Part(s) receiving tuning
data. [Part number 1 is selected by default each time
the unit is turned on.]
O Pressthe Number button(s) which correspond(s)
to the desired Part number(s).
The LED(s) on the selected button(s) will light(s). To
prevent a Part from receiving tuning data, press the
corresponding Number button so that its LED is dark.
Ө Press [MIDI] again.
The LED on the [MIDI] button will light momentarily
and then go out. All the Number buttons will go out at
the same time, as the tuning data is transmitted to the
selected Part(s).
Bender Mode
In the Bender mode, you select the MIDI channel
over which tuning data (Pitch Bend messages) will
be transmitted to your keyboard or sound module.
O Press [MIDI].
The LED on the [MIDI] button will begin to flash and
one of the 16 Number buttons (one for each MIDI
channel) will light. The Number button which lights
corresponds to the selected MIDI channel. [MIDI
channel 1 is selected by default each time the unit is
turned on.]
Ө Press the Number button which corresponds to
the desired MIDI channel number.
The LED on the selected Number button and on the
[MIDI] button will light momentarily and then go out.
на
FROLAND
ASC-10 -
Send "оса! On/Off' Message
If your keyboard features 'Local' control, you can
easily turn it on or off from the ASC-10. Set your
keyboard to 'Local Off' when using the ASC-10 in
the Bender mode:
Press and hold [MIDI] and then press [A+].
A "Local Off' message is transmitted to your keyboard.
To return to 'Local On'...
Press and hold [MIDI] and then press [A].
А "оса! On' message is transmitted to your keyboard.
Send 'Bend Range +2' Message
If you intend to use the ASC-10 in the Bender mode,
the bend range of your keyboard must be set to +2
(semitones). A*+2* bend range message is automati-
cally sent whenever you select the Bender mode. If,
however, you wish to make the setting manually...
Press and hold [MIDI] and then press [B].
A 'Bend Range +2' message is transmitted to your
keyboard.
Advertisement
Table of Contents
