Krups XP3440 Instruction Manual page 19

PROBLEMS POSSIBLE CAUSES
Water is leaking under the There's an internal leak.
appliance.
The drip tray has not been
fitted correctly.
The drip tray is overflowing. Empty and carefully rinse
The cups have been filled The filter holder is clogged. Please
unequally.
The pump is abnormally There is no water in the
hot. tank.
The espresso leaks over The filter holder is not
the edges of the filter. positioned correctly.
The rim of the filter holder
is encrusted with coffee
grounds.
The
positioned incorrectly.
Your espresso tastes bad. The appliance was not
rinsed
descaling.
31
SOLUTIONS
Check that the tank is
fitted correctly. If the leak
continues, do not use
the appliance, contact an
approved service centre.
Check that the drip tray is
pushed to the back of the
appliance.
the drip tray and replace.
refer
paragraph on CLEANING
AND SERVICING
servicing your filter holder.
Fill the tank with water
and re-initiate the pump
(see paragraph: USING
FOR THE FIRST TIME).
Avoid emptying the tank
completely.
Put the filter holder in place
and lock it (turning it from left
to right as far as it will go).
Remove excessive coffee
grounds that prevent the
filter holder to be locked.
Remove excessive coffee
grounds and clean the grid
through which water passes
with a damp sponge.
soft capsule is Check that the
capsule has been inserted
correctly: the paper must
not protrude out of the
filter.
Rinse the appliance
correctly after according to
instructions and check the
quality of the coffee.
PROBLEMS
The appliance
work
The steam wand does not
foam the milk.
to the
for
If it is not possible to identify the cause of a malfunction, please contact an approved
service centre. Never disassemble the appliance. (if the appliance has been
disassembled, the guarantee may no longer be valid).
ELECTRIC OR ELECTRONIC PRODUCT AT END
Environment protection first!
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
soft
the
POSSIBLE CAUSES
doesn't The pump has been Fill the tank with water
deactivated due to a lack and re-initiate the pump
(see paragraph: USING
of water.
FOR THE FIRST TIME).
Avoid emptying the tank
completely.
The removable water tank Position the water tank
has been fitted incorrectly. correctly.
The steam wand is Descale the steam wand
blocked or has an excess according to the paragraph
of limescale. on Descaling or unblock it
using a needle.
The milk is too hot. Use fresh milk.
The shape of the container Use
is not suitable. Follow the milk foaming
instructions (paragraph on
STEAM FUNCTION).
OF LIFE
SOLUTIONS
a small jug.
32