Table of Contents
Advertisement
4-3 HOW TO INSTALL VOLUME (VR901) AND CAM WHEEL
STOPPER
RING
(4) MARK_
MATCHING
POSITION
MARK(D)
CHASSIS
CAPSTAN
HOLDER
FIT THIS PART To THE
RIGHT ENO OF CHASSIS.
POTENTIO
GEAR
MOTOR CHASSIS(A)
(2) MARK MATCHING POSITION
POTENTIO
GEAR
CHASSIS
Fig.4-3.
MARK (A)
MARK (B)
1) Apply Molybdenum coat on the area of 360° from the
5) Fit the stopper ring in the groove of the capstan holder
bottom to the upside 2mm of groove as shown Fig. 4-3-@).
2) Fit the right end of Mark (A) to the center of Mark (B)
CAUTIONS
:
as shown Fig. 4-3-@).
1. Make sure that the teeth on the periphery of cam wheel
3) Apply Molybdenum coat on the ®, ® and © shown Fig.
and the cam are absolutely free from any scratch, cut, etc.
4-3-@).
2. Make sure that Molybdenum
coat is applied on the
4) Set the CAM
WHEEL
on the CAPSTAN
HOLDER
specified area only.
(ensure that the cam wheel and potentio gear in meshed
properly).
4-3-@),
OO
—————
SERVICE
MANUAL —————————$—$—$—$
6
Advertisement
Table of Contents
