Ardo alyssa Troubleshooting Manual

Hide thumbs Also See for alyssa:

ardo alyssa

PROBLEM

My Ardo Alyssa pump

doesn't power on

My Ardo Alyssa pump

doesn't power on

Troubleshooting

Check that the Alyssa battery is fully

charged for at least 2 hours

Press the On/Off Power Button for at least

2 seconds to turn the Alyssa on or off; this

is a safety feature so that Alyssa is not

accidentally turned on or off

Make sure your breast pump is connected

to power

Try an alternative power outlet

Make sure your power adapter or USB

cable are not damaged

If your Alyssa still doesn't power on,

contact Ardo customer service

SOLUTION

Table of Contents

Need help?

Do you have a question about the alyssa and is the answer not in the manual?

Page 1 2 hours doesn’t power on Press the On/Off Power Button for at least 2 seconds to turn the Alyssa on or off; this is a safety feature so that Alyssa is not accidentally turned on or off...
Page 2 Ardo customer service If you are not using your pumpset which came with Alyssa, make sure you are using the correct pumpset cover with insert in the lid My pump has low or...
Page 3 Troubleshooting PROBLEM SOLUTION If pumping only on one side (single My pump has low or pumping), make sure the second tube no suction connector is closed Make sure the tube connector is properly My pump has low or...
Page 4 Make sure the lip valve is intact with no tears, cracking, or lips sticking together no suction Ardo lip valves should have a slight opening between the lips Replace lip valves if they are not intact Make sure the membrane pot is lying flat...
Page 5 Troubleshooting PROBLEM SOLUTION Make sure the smooth side of the My pump has low or membrane pot is facing outwards with the no suction ridges on the inside Make sure the lid cover is properly closed Line up the mark on the top of the flange...
Page 6 Troubleshooting PROBLEM SOLUTION If using a hard insert, make sure the insert is assembled correctly Gently push the insert into the breast shell Twist and turn the insert to the right to My pump has low or create an air tight seal...