Installation Instruction; Before Installing The Wind Sensor; Installing The Nmea2000 On The Mast - Calypso Instruments ULP NMEA2000 User Manual

3. Installation Instructions
Before installing the unit:
1. Plug in the ULP NMEA2000 to the NMEA2000 cable/backbone.
2. On your display/plotter, choose the ULP NMEA2000 as the wind source in the
settings.
*The manner to do this will vary depending on the brand of the display/plot-
ter. Please refer to your display/plotter's manual.
3. Verify wind data is appearing on your NMEA2000 display/plotter.
Installing the ULP NMEA2000 on top of the mast.
1. Place the ULP N2K on top of the mast or a pole away from any object that can
disturb the airflow to the wind sensor in a 2 meter radius (6.5 feet).
2. Connect it to the NMEA2000 cable. If the cable is longer than 6 meters (19.7
feet), the cable needs an in-line terminator. *
3. Make sure the North Mark is facing the bow of the boat to obtain correct wind
readings.
4. Tighten the screws to fasten the wind sensor to the mast.
*Cables with in-line terminators and in-line terminators are available accessories on
our website: www.calypsoinstruments.com.
ULP NMEA2000
3