Operation - EINHELL AGILLO 36/255 BL Operating Instructions Manual

The harness is fi tted with a quick-release
mechanism. Pull the red part of the harness (Fig.
20) if you need to remove the equipment quickly.
5.10 Installing the rechargeable batteries
Push the rechargeable batteries into the battery
mounts provided on the left and right on the
equipment (Fig. 2/Item 1). The battery will be
heard to click into place when it has been pushed
fully in (Fig. 1). To take out the battery, press the
pushlock button (Fig. 21/Item 36) and remove the
battery.

6. Operation

Please note that the statutory regulations
governing noise abatement may diff er from one
location to another.
Danger! The guard hood must be fi tted when
carrying out work.
6.1 Switching the equipment on and off ,
adjusting the speed (Fig. 22)
Switching on and setting the speed
Press the safety lock-off (3) and press the On/
Off switch (2) at the same time. Adjust the speed
during operation by pressing the On/Off switch to
a greater or lesser extent. The harder you push,
the higher the speed.
Switching off
Release the On/Off switch.
6.2 Practical tips
Practice all the work steps with the motor
switched off and without the rechargeable battery
before you start to use the equipment. Only use
the cutting line to mow grass that is dry. If the
grass is long, the grass must be cut shorter in
stages (Fig. 23).
Extending the cutting line (Fig. 24)
Danger! Do not use any kind of metal wire or
metal wire encased in plastic in the line spool.
This may cause serious injuries to the user.
The grass trimmer has a semi-automatic line
extension system (automatic jog line feed).
Each time you activate the semi-automatic
line extension system, the line is automatically
extended to ensure that you can cut your lawn
with the perfect cutting width at all times. To
Anl_Agillo_36_255_BL_SPK7_USA.indb 18 Anl_Agillo_36_255_BL_SPK7_USA.indb 18
EN
extend the cutting line, run the motor and tap the
line spool on the ground. This will automatically
extend the line. The blade on the guard hood
will cut the line to the permissible length. Please
note that the more often you activate the semi-
automatic line extension system, the more the line
will wear.
Note: If the line is too long when you use the
equipment for the fi rst time, the surplus end of it
will be cut by the blade on the guard hood. If the
line is too short when you start the equipment
for the fi rst time, press the knob on the line spool
and pull the line hard. When you then start the
machine for the fi rst time the line will be cut to the
perfect length automatically.
Using a brush or similar, carefully remove all
residual grass from the underside of the guard
hood at regular intervals.
Diff erent cutting methods
When the equipment is correctly assembled it
will cut weeds and long grass in places which are
diffi cult to access, e.g. along fences, walls and
foundations and also around trees. It can also
be used for "mowing" down vegetation so that a
garden can be better prepared or a certain area
cleared down to the soil.
Please note: Even if it is used carefully, cutting
around foundations, stone or concrete walls, etc.
will result in the line suff ering above normal wear.
Trimming/mowing
Swing the trimmer from side to side in a scything
motion. Always keep the line spool parallel to the
ground. Check the site and decide which cutting
height you require. Guide and hold the line spool
at the required height to obtain an even cut (Fig.
25).
Low trimming
Hold the trimmer right in front of you at a slight
angle so that the underside of the line spool is
above the ground and the line strikes the correct
target. Always cut away from yourself. Never draw
the trimmer towards yourself.
Cutting along fences/foundations
Approach wire mesh fences, lath fences, natural
stone walls and foundations slowly so that you
can cut close to them without striking the obstacle
with the line. If, for example, the line strikes
stones, stone walls or foundations, it will wear or
- 18 -
07.12.2023 14:06:06 07.12.2023 14:06:06