Table of Contents
Advertisement
9.2 Setting and starting a
programme
The Auto off function
This function decreases energy consumption
by deactivating automatically the appliance
when it is not operating.
The function comes into operation:
• When the programme is complete.
• After 5 minutes if a programme was not
started.
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in programme selection mode.
2. Close the appliance door.
3. Press
repeatedly until the indicator of
the desired programme is on.
The display shows the programme duration.
4. Set applicable options if desired.
5. Press
to start the programme.
• The indicator of the running phase is
on.
• The programme duration counts down
in minutes.
Starting a programme with delay start
1. Set a programme.
2. Press
repeatedly until the display
shows the desired delay time (from 1 to
24 hours).
3. Press
to begin the countdown.
• The indicator
• The remaining time counts down in
hours. The final hour is displayed in
minutes.
When the countdown is complete, the
programme starts and the indicator of the
running phase is on. The indicator
Opening the door while the appliance
operates
Opening the door while a programme is
running stops the appliance. It may affect the
is on.
is off.
energy consumption and the programme
duration. After closing the door, the appliance
continues from the point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
Do not try to close the appliance door
within 2 minutes after AirDry
automatically opens it as this may cause
damage to the appliance.
If, afterwards, the door is closed for at
least 3 minutes, the running programme
ends.
Cancelling the delay start while the
countdown operates
When you cancel the delay start, you have to
set a programme and options again.
Press and hold simultaneously
until the appliance is in programme selection
mode.
Cancelling the programme
Press and hold simultaneously
until the appliance is in programme selection
mode.
Make sure that there is detergent in the
detergent dispenser before you start a new
programme.
End of the programme
When the programme is complete, the Auto
off function switches the appliance off
automatically.
All buttons are inactive except for the on/off
button.
Close the water tap.
and
and
ENGLISH
15
Advertisement
Table of Contents
