MTD Cub Cadet 950 Owner's Manual page 19

Step 21. Pinch belt together so that it is not in the
pulley groove, and the lower pulley can be
pushed towards the engine.
Step 22. Pivot the control arm back to its original
position and reinstall the six-speed cable into
the slot.
Step 23. Check and make sure the belt is routed
inside the pulley halves and the belt guard pin
Step 24. Reinstall the bolt securing transmission to rear mower housing.
Step 25. Pivot the baffle back to its original position and secure with three hex screws earlier removed. You
will need a 3/8" socket for these screws.
Step 26. Lightly lubricate the inside of the blade adapter and reinstall spacer, wave washer, blade adapter
assembly and the blade in the correct order.
Step 27. Tighten the hex bolt to secure the blade. Follow recommended torque which is 450-600 in. lbs.
SECTION 10: LUBRICATION
WARNING:
Always stop engine and disconnect spark plug wire before cleaning, lubricating or doing
any kind of work on the lawn mower.
Blade Control:
Lubricate the pivot points on the blade control handle and the brake cable at least once a
19