EX S&m Programmable
Controllers
Monitor mode
If an kroorred code
is
entered,
'Err"
is
displayed:
4)
Push [MONITOR] to register the
new
code.
3) Enterlng a new
entry
code
This fundion allows a new code to be entered. Before
the code can
be
changed, the existing one
must
be
released, then deleted. Follow the procedures in 1) and
2) to do this.
To enter the new code:
7)
Push [CLEAR]
2)
Push [SETTING]. Thedisplayshown belowap-
zero$ an entry code akeady exists and this
pears. Note that if hyphens appear instead
of
procedure cannot
be used.
3 )
Push [DEVICE +].
"SET"
appears to the left
Type in the new code.