Midea MDF24P2B Series User Manual page 26

To refill the rinse aid dispenser
1. Lift up the end tab of rinse aid
cover to open.
3. Press the rinse aid cover down
firmly to close.
WARNING
Do not fill the reservoir above the full level indicator. Excess rinse aid
can overflow during the wash cycle.
To adjust the rinse aid setting
You can adjust the amount of the rinse aid released during the rinse
aid according to the following steps:
1. Close the door and power on the dishwasher.
2. Within 60 seconds after step 1, press the CYCLES button more than 5
seconds to enter into the setting mode, the rinse aid indicator will blink
quickly.
3. Press the CYCLES button to select the proper setting according to
your using habits. The setting will change in the following sequence:
d3->d4->d5->d1->d2->d3.
4. Without any operation in 5 seconds or press the Power button to
to complete the setting and exit the setting mode.
26
2. Fill the rinse aid dispenser with
liquid rinse aid until full.
overfill.
NOTE:
Use the viewing port when filling
the rinse aid reservoir.
DO NOT