Specifications - Makita UB121DZ Instruction Manual

ENGLISH
Explanation of general view
© Push button
© Battery cartridge
@ Nozzle
0
©
©
Blower outlet
Suction inlet
Dust bag
@ Fastener
® Screw
@ Set plate
SPECIFICATIONS
Model
UB121D
UB141D
UB181D
Capacities
Air pressure (water column).
0 - 550 mm
0 - 550 mm
Air volume.
. 0-2.3mtymin.
0 - 2.3 m^/min.
0 - 2.3 m®/min.
No load speed (min"')... . 0-18,000
0-18,000
0-18,000
Overall length...
. 516 mm
516 mm
530 mm
Net weight (with battery cartridge). ..... 1.8 kg
1.9 kg
2.1 kg
Rated voltage.
. D.C.12V
D.C.14.4V
D.C.fsV
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Safety hints
For your own safety, please refer to the enclosed
safety instructions.
ADDITIONAL SAFETY RULES
FOR TOOL
1. Read this instruction manual and the charger
instruction manual carefully before use.
2. Be aware that this tool is always in an operat¬
ing condition, because it does not have to be
piugged into an electrical outlet.
3. Always use protective goggies, a cap and
mask when using the blower.
4. Never point the nozzle at anyone in the vicinity
when using the blower.
5. Always use the dust bag when collecting dust,
chips and the like.
6. Do not collect still smoldering cigarette ashes,
freshiy cut metais shavings, screws, naiis and
the iike.
7. Never block suction inlet and/or blower outlet.
Increased motor revolution may cause dan¬
gerous fan breakage.
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
installing or removing battery cartridge
(Fig. 1)
• Always switch off the tool before insertion or
removal of the battery cartridge.
• To remove the battery cartridge, withdraw it from the
tool while pressing the push buttons on both sides
of the cartridge.
• To insert the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way until
it locks in place with a little click. If not, it may
accidentally fall out of the tool, causing injury to you
or someone around you.
• Do not use force when inserting the battery car¬
tridge. If the cartridge does not slide in easily, it is
not being inserted correctly.
Charging
Charge the battery cartridge with your Makita cahrger
properly before use.
Following batteries can be used for this blower.
For UB121D
Battery 1200, 1220, 1202, 1202A, 1222, 1233, 1234,
1235
For UB141D
Battery 1420, 1422, 1433, 1434, 1435
ForUB181D
Battery 1822, 1833, 1834, 1835
Blowing (Fig. 2)
For dust blowing, attach the nozzle to blower outlet,
turning clockwise to lock it in place.
Dust suction (Fig. 3 & 4)
For dust suction, fit nozzle onto suction inlet and dust
bag onto blower outlet.
After the bag fills with dust, empty the contents of the
dust bag into a dust bin by releasing the fastener.
CAUTION:
Empty the dust bag before it becomes too full, or the
suction force weakens.
3