Oase 33885 Commissioning page 14

Product overview
1 Connection OASE Control Aquarium Transformer
2 Connection for device with OASE Control functions from the aquarium-keeping segment.
3 Status LED (→ Operating conditions indicated by the Status LED)
4 Service button (→ Service button functions)
Operating conditions indicated by the Status LED
LED
–
Green
Yellow
Green+ yellow Lit
Red
14
LED status Description
Off The Aquarium Controller is switched off.
Lit A direct connection is established.
Flashing slowly A connection to a WiFi network is established.
(1× per second)
Lit The Aquarium Controller is starting.
Flashing slowly The Aquarium Controller is attempting to establish a connection to
(2 s on, 1 s off) the router. This can take several minutes.
• If no connection is found, check the WiFi connection. If necessary,
The Aquarium Controller is in firmware update mode.
Green is lit, yellow is A firmware update is in progress.
flashing
Flashing An internal error has occurred; recommended procedure:
• Disconnect the power supply, wait for approx. 10 seconds, then re-
• If the error remains active, ...
reduce the distance between the Aquarium Controller and the
router.
establish the power supply.
− use the "OASE Control" app to check for new firmware. If neces-
sary, install new firmware.
− reset the device to its factory settings and restart it. (→ Service
button functions)
− contact the OASE service.
EAC0004