Amana P1323201M Service Manual page 16

Installation Instruction
6. Roof-vented installation: Align the damper/duct
connector with the vent on top of the microwave
oven. Damper should be on top of tab. Use two
tapping screws (bright-colored) to attach damper/
duct connector to the microwave oven.
damper
NOTE: Damper/duct connector must be attached to
microwave oven after microwave oven is
installed.
7. Roof venting installation: Install ductwork through the
vent opening in the upper cabinet. Complete the
venting system through the roof according to the
method needed. See, Preparing Venting System
section. Use caulking to seal the exterior roof
opening around the exhaust cap.
8. Use the power supply cord clamp to bundle the
power supply cord. Install the power supply cord
clamp inside the cabinet.
duct
RS21000008 Rev. 0
9. Grasp filter screen with one hand holding the ring
and the other hand holding the opposite end. Insert
the end of the filter screen without ring into the
opening and slide towards the side of the microwave
oven. Insert ring end of filter screen into the opening
and slide entire screen towards the center of the
microwave until screen is securely in position.
Repeat for other filter screen.
10.Plug in the power supply cord.
power
supply
cord
clamp
16