LumenRadio CRMX Galileo MAX Manual

MANUAL CRMX Galileo MAX

APPLICATION AREA

The CRMX Galileo MAX is a wireless lighting control product. It is designed to be
used indoors or outdoors when installed in an IP65 or higher rated environmental
enclosure.
CRMX Galileo MAX is used to replace the cable in DMX-512A systems. CRMX
Galileo MAX can be used together with any CRMX compatible device using
either CRMX Classic or CRXM 2 Modes. CRMX Galileo MAX can also be configu-
red to operate in W-DMX mode where it can communicate with W-DMX com-
patible devices.

GENERAL

All personnel must familiarize themselves with the instructions in this leaflet befo-
re using this product. This product must not be used if damaged. For additional
documentation for CRMX Galileo series or CRMX in general, scan the QR code
on this leaflet or visit www.lumenradio.com.

WARRANTY

All warranty claims for this product shall be directed to the local distributor/reseller.
Warranty is deemed void if:
1. The product is modified, repaired or otherwise altered unless it has been
directed by LumenRadio AB, or
2. The serial number on the product (the QR code) has been compromised.

SYSTEM OVERVIEW

A CRMX system replaces the need to use expensive and cumbersome DMX ca-
bles. Place the Galileo MAX unit in close proximity to the lighting controller, or
connected to a local Ethernet network, and let it wirelessly trasmit the DMX and
RDM data to Galileo RX receiver units or other CRMX compatible receivers –
for instance built-in receivers in wireless-ready fixtures from any of LumenRadio's
partners.
DMX data can be locally daisy-chained with a cable between fixtures that are
physically close to each other.
The signal can be repeated to extend the range using a Galileo RX unit with the
repeater option.

SAFETY

Only qualified electricians or service personell trained by LumenRadio may
perform installations with this product. Always follow local electrical code and
regulations.
This products shall only be used together with limited power supplies with UL
insulation class II.
Do not use the product if the product is damaged. Only use cables within the
specified conductor sizes. This product may not be connected directly to mains
power.

INSTALLATION

1. Verify that the product has no physical damage.
2. Clip the unit onto a DIN rail. If installed outdoors, this must be performed
in a minimum IP65 rated environmental enclosure.
3. Mount the antenna or, if installed in an an enclosure, mount the antenna
coax cable.
4. Connect the power supply in accordance with the specified voltage.
5. Connect the Ethernet cable to the RJ45 connector.
6. Power on and verify that the unit starts up correctly without any errors.
7. Set the unit up for the correct protocol to use. See further details on this by
scanning the QR code on this guide.
Copyright © LumenRadio AB 2024, All Rights Reserved
lumenradio
CRMX Galileo MAX
Scan for additional
information
www.lumenradio.com

BOX CONTENT

1 pc. CRMX Galileo MAX unit
1 pc. 2-pin terminal plug for power

SPECIFICATIONS

Power supply:
Max. power consumption:
Self-healing fuse:
Rated wire size:
IP rating:
Dimensions (W x H x D):
Weight:
Antenna connector:
Operating temp. range:
Storage temp. range:
Humidity:
Frequency range CMRX/W-DMX: 24024-2480 MHz (ISM band)
Frequency range WiFi:
Max. RF power CRMX/W-DMX:
Max RF power WiFi:
Supported protocols:
Supported RF protocols:
Ethernet:
PoE:
USB:

LEGAL

CRMX is a trademark of LumenRadio AB, W-DMX is a trademark of Wireless So-
lution Sweden AB. Wireless Solution Sweden AB is a fully-owned subsidiary of
LumenRadio AB. DMX-512A, RDM and Streaming ACN refers to ANSI national
standards developed and maintained by ESTA, Entertainment Services and Tech-
nology Association. Art-Net Trademark Designed and Copyright Artistic Licence
Engineering Ltd.
This product makes use of US patents 7,432,803; 8,457,023; 10,208,680; EU pa-
tents EP 2415317, EP 2803248; China patents CN 102369774, CN 104041189B
and others.
Verison of this quick start guide: Version 1 (2023-12-04)

MANUFACTURER

LumenRadio AB
Johan Willins gata 6
416 64 Gothenburg
Sweden
FCC ID: XRSTIMOMWAN301
FCC ID:2ABCB-RPIRM0
IC ID: 8879A-TIMOMWAN301
IC ID: 20953-RPIRM0
LUMENRADIO
by LumenRadio
1 pc. RP-SMA antenna
1 pc. Quick start guide (this leaflet)
12-24 VDC +/- 10%
8.5W
Yes
0.2 - 1.5mm2
24-16 AWG
IP X0
107 x 93 x 58.7 [mm]
195g
RP-SMA
-20 to +55°C
-30 to +80°C
0–90% non-condensing
5170-5330MHz (ISM band)
5490-5590 MHz (ISM band)
100mW (280mW in US)
50mW
Art-Net, Streaming ACN, RDM
CRMX, CRMX 2 , W-DMX G3 & G4S
10/100 Mbps via RJ45 connector
IEEE 802.3af
Version 2.0 (only for software updates)
LumenRadio
Alfred-Herrhausen-Allee 3-5
DE-65760 Eschborn
Germany
E115504
UL62368-1
CSA C22.2 No. 62368-1
www.lumenradio.com