Table of Contents
Advertisement
5
(7) Remove the four screws. (ABA1052)
(8) Remove the Heat Sink 85 with side-A of the
D-AMP_S ASSY facing upward.
Note: When replacing the Heat Sink 85, attach
the Tape in the center of each side.
Tape
Tape
(9) Remove the four Heat Sink Spacers.
(10) Remove the seven Heat Cond Sheets.
Note on assembling :
To attach the D-AMP_S ASSY in the correct
position, refer to the "[1] Attach the
D-AMP_S ASSY" of "Assembling of Digital
Amplifier Block".
[4] DIGITAL MAIN ASSY
Remove the Bonnet 65 by removing the 18
screws.
-----------------------------------------------------------------
[4-1] DIGITAL MAIN ASSY
(1) Release the cables from the Cord Clamper
HL.
(2) Remove the HDMI Cable (ADX7777) by
disconnect the connector, and then connect
the another normal HDMI Cable.
Note: Don't connect the HDMI Cable provided
with the product to prevent damage to the
HDMI connector for the DIGITAL MAIN
ASSY. Instead, use the another normal
HDMI Cable to prevent a load from being
applied to the HDMI connector.
Always connect the HDMI Cable because
the iPod iPhone iPad LED blinks, which
causes a shutdown, if the power is turned
on without the cable connected.
Notes on assembling
∗1: Don't touch the cables to the Fuse Holder.
5
6
Heat Sink 85
9
HDMI Cable
Front
SC-63
6
7
7
7
D-AMP_S ASSY (side-B)
7
9
10
10
D-AMP_S ASSY
Fuse Holder
∗1
1
2
JA8003
7
8
7
Heat Sink 85
9
9
10
Cord Clamper /HL
FRONT HDMI USB ASSY
8
A
B
C
D
E
F
59
Advertisement
Table of Contents
