Pioneer SC-63 Service Manual page 51

5
Notes on assembling
∗6: Bend the 39P FCC. (ADD7753)
∗7: Doesn't touch the cables to a top of screws.
∗8: Twist the PCB binder around the 2P Housing
ASSY (ADX7760) and tilt in the direction of
the blue arrow, so that it don't contact the
Heat Sink.
∗9: Doesn't touch the cables to the Heat Sink.
[2] Rear Section
Remove the Bonnet 65 by removing the 18
screws.
-----------------------------------------------------------------
[2-1] Rear Section
(1) Release the cables from the Cord Clamper
HL.
(2) Remove the HDMI Cable (ADX7777) by
disconnect the connector, and then connect
the another normal HDMI Cable.
Note: Don't connect the HDMI Cable provided
with the product to prevent damage to the
HDMI connector for the DIGITAL MAIN
ASSY. Instead, use the another normal
HDMI Cable to prevent a load from being
applied to the HDMI connector.
Always connect the HDMI Cable because
the iPod iPhone iPad LED blinks, which
causes a shutdown, if the power is turned
on without the cable connected.
Notes on assembling
∗1: Doesn't touch the cables to the Fuse Holder.
(3) Disconnect the connector.
(4) Release the cables from the PCB binders.
(5) Remove the 39P FFC (ADD7746) by
disconnect the two connectors.
(6) Release the cable (PF04PG-S10) from hook
of the VREG GUARD ASSY.
(7) Disconnect the connector.
(8) Disconnect the two connectors.
(9) Remove the screw. (BBZ30P060FCC)
Notes on assembling
∗2: PCB binder tilt in the direction of the blue
arrow. Doesn't touch the other cables.
5
6
∗7
V-REG ASSY
∗7
∗6
Front
USB RECT ASSY
Heat Sink
Front
∗8
ADX7760
1
HDMI Cable
JA8003
Front
DIGITAL MAIN ASSY
CN601
4
39P FCC
PF04PG-S10
VREG GUARD ASSY
Front
SC-63
6
7
ADX7776
39P FCC
Cord Clamper HL
∗9 5P Housing ASSY
HDMI Cable
FRONT HDMI USB ASSY
Fuse Holder
∗1
Cord Clamper HL
2
FRONT HDMI USB ASSY
CONNECT ASSY
8
x 2
JA9605
3
9
5
∗2
∗2
6
4
5
CN7554
7
7
8
A
B
C
D
HDMI Cable
E
4
∗2
CN7901
V-REG ASSY
F
51
8