Turning The Power On And Off; Using Headphones; Setting The Volume; Connect The Power Cord - Yamaha Clavinova CVP-204 Owner's Manual

Turning the Power On
and Off

Connect the power cord

1
Insert the plugs at the ends of the cord, one into the
AC INLET on the Clavinova, and the other into a
standard AC outlet.
In some areas, a plug adapter may be provided to
match the pin configuration of the AC wall outlets in
your area.
CVP-206
(The shape of plug differs depending on locale.)
2
Press the [POWER] switch.
→
The main display appears in the LCD display. The
drive lamp below the lower right end of the
keyboard also lights.
POWER
ON OFF
A
B
C
D
E
BALANCE
CHANNEL
ON / OFF
PART
When you're ready to turn off the power, press the
[POWER] switch again.
→
Both the display and the drive lamp below the
right end of the keyboard will turn off.

Adjusting the display contrast

If the LCD is difficult to read, adjust the
contrast with the [LCD CONTRAST]
knob at the right of the LCD.
CVP-204
The drive lamp lights.
F
G
H
I
J
LCD
CONTRAST

Setting the volume

Use the [MASTER VOLUME] dial to adjust the volume to
an appropriate level.
MASTER VOLUME
MIN
CAUTION
Do not use the Clavinova at a high volume level for a long period of
time, or your hearing may be damaged.

Using headphones

Connect a pair of headphones to one of the [PHONES]
jacks.
Two [PHONES] jacks are provided.
Two sets of standard stereo headphones can be plugged
in. (If you are using only one pair of headphones, you
can plug them into either of these jacks.)
CVP-206
INPUT MIC.
MIC. LINE PHONES
VOLUME LINE IN
MIN MAX
Using the Headphone Hanger
A headphone hanger is included in the CVP-206/204
package so that you can hang the headphones on the
Clavinova. Install the headphone hanger using included
two screws (4 10 mm) as shown in the figure.
CAUTION
Do not hang anything other than the headphones on the hanger.
Otherwise, the Clavinova or the hanger may be damaged.
CVP-206
FADE IN / OUT
MAX
CVP-204
CVP-204
CVP-206/204
17