Table of Contents
Advertisement
en-us Basic Operation
Press the required program.
1.
→ "Programs", Page 21
a The display shows the program settings.
If required, adjust the program settings.
2.
→ "Adjusting the program settings", Page 24
12.3 Adjusting the program settings
Depending on the program and program progress, you
can adjust or activate/deactivate the settings.
Requirement: A program has been set.
→ "Setting a program", Page 23
Adjust the program settings.
▶
→ "Buttons", Page 19
Observe the information about operating logic
→ Page 16 .
Note: The program settings are not saved permanently for
the program.
12.4 Saving the program settings
You can save your individual program settings as
favorites.
Requirements
¡ A program has been set.
→ "Setting a program", Page 23
¡ The program settings have been adjusted.
→ "Adjusting the program settings", Page 24
Press and hold Favorite for approximately 3 seconds.
▶
Press Favorite to call up the saved program.
Note: To overwrite the saved program, repeat the steps
above.
12.5 Loading laundry
Note: To prevent creasing, note the maximum load for the
programs.
→ "Programs", Page 21
24
Requirements
¡ The laundry is prepared and sorted.
→ "Laundry", Page 23
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry trapped in the door.
12.6 Starting the program
Requirement: A program has been set.
→ "Setting a program", Page 23
Press
.
▶
a The display shows the program duration or the program
end time.
a After the program has ended, the display shows: "End".
Note: If "Hot" appears, the appliance cools the laundry.
When "Hot" goes out, the laundry has cooled down.
12.7 Adding laundry
After the program starts, you can remove or add laundry at
any time.
Press
.
1.
The cooling process starts automatically after
approximately 30 seconds and cools down the laundry
while the drum is rotating. If you want to avoid or cancel
the cooling process, open the door.
→ "Display", Page 17
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
12.8 Terminating the program
Press
.
1.
Open the door.
2.
Remove the laundry.
3.
→ "Removing the laundry", Page 24
12.9 Removing the laundry
Open the door.
1.
Remove the laundry from the drum.
2.
12.10 Put the appliance into standby mode
Press .
▶
Advertisement
Table of Contents
