Table of Contents
Advertisement
en-us Troubleshooting
Issue
The drying time is too long.
Water is leaking from the
appliance.
Water overflows when filling the
water tank.
Laundry is too damp.
36
Cause and troubleshooting
The lint screen is soiled.
→ "Cleaning the lint screen", Page 25
▶
The ambient temperature is greater than 86 °F (30 °C).
Ensure that the ambient temperature is below 86 °F (30 °C).
▶
The ambient temperature is lower than 59 °F (15 °C).
Ensure that the ambient temperature is above 59 °F (15 °C).
▶
Insufficient air circulation at the appliance's installation location.
Ventilate the appliance's installation location.
▶
Insufficient condensation for automatic self-cleaning when permanently using the
crease-removal function.
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance is kept clear.
▶
The heat exchanger is soiled.
Run the basic appliance care program on the appliance.
▶
→ "Appliance care", Page 30
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 11
▶
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected correctly.
▶
The water tank for the crease-removal function is empty.
Refill water tank.
▶
→ "Filling the water tank", Page 27 .
The water tank has been filled.
Note: The overflowing water is harmless.
Do not pour any more water into the water tank.
▶
The water tank filter is soiled.
→ "Cleaning the water tank filter", Page 32 .
▶
Unsuitable program for the type of fabric.
Set a timed program for subsequent drying.
▶
→ "Programs", Page 21
There has been a power failure.
Check whether the lighting in your kitchen or other appliances in the room are
▶
working.
The load is too large.
Observe the maximum load capacity of the
▶
→ "Programs", Page 21 .
After the end of the program, warm laundry feels damper than it actually is.
Remove the laundry from the drum as soon as the drying program has finished.
1.
Spread out the items of laundry to cool.
2.
Unsuitable dryness level set.
→ "Changing the dryness level", Page 21 .
▶
Dryness level not adjusted.
→ "Adjusting the dryness level", Page 21 .
▶
Load too small.
Set a timed program for subsequent drying.
▶
→ "Programs", Page 21
Moisture sensor dirty.
Advertisement
Table of Contents
