Advertisement
Insert the batteries in
the correct polarities
1®,O).
i_!:_ _
...........................................................................
Remote control signal sensor
oool
Transmission
window
30 °
Avoid any obstacles
About 7 meters (23 feet) in
front of the signal sensor.
(The actual range will
depend on the angle at
which the remote control is
used.)
l_l;IFJ
[]
• Thoroughly
clean the battery compartment before inseding
new
batteries.
• Do not mix old and new batteries, or batteries of different types
(carbon and alkaline, etc.).
• If you will not use the remote control for a long period of time,
remove the batteries and store them in a cool, dark place.
• Do not use rechargeable type batteries.
• Do not attempt to recharge alkaline or carbon batteries.
• Always remove old, weak or worn-out batteries promptly and dis-
pose of them properly.
• Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
• if the leaking electrolyte comes into cSi'itact'with _ldn or 'clothes,
flush with water immediately.
When you need to replace these batteries
Use two R6/LR6, AA, UM-3 batteries.
[]
Be sure the transmission window and the signal sensor are free
from dust. Excessive dust might affect performance.
The operation may not be correct if direct sunlight or another strong
light source strikes the signal sensor of this unit. If there is a prob-
lem, place the unit away from the light source.
Advertisement
