Supra Vision Control Owner's Manual page 29

The system will attempt to fill and/or drain ballasts to reach a static pitch, roll and amplitude setpoint. If pitch or
roll setpoints cannot be achieved, a pop-up will occur indicating this to the driver (AutoWake will remain in this
state).
(6) Static AutoWake Achieved: This will occur when:
•
Boat is turned on
•
AutoWake is turned on
•
Actual speed is less than 3mph
•
Pitch, roll and amplitude values match their respective setpoints.
If pitch or roll setpoints cannot be achieved, a pop-up will occur indicating this to the driver and AutoWake will
remain in Static AutoWake Active state. If pitch and roll are achieved and amplitude is as close as possible to
setpoint, the AutoWake system will go to this state.
Adjusting the Cruise Speed
Touch the – or + buttons in the upper right corner to adjust the
Cruise Speed.
2023-11-30 29 2301122