Yamaha Clavinova CLP-170 Software Installation Manual page 7

Installing the driver on a Windows XP system
1 Start the computer.
2 Select [Start | Control Panel].
If the control panel appears as shown below, click "Switch to
Classic View" in the upper left of the window.
All control panels and icons will be displayed.
3 [System | Hardware | Driver Signing | File Signature Verification],
and check the radio button to the left of "Ignore -Install all files,
regardless of file signature" and click [OK].
4 Click the [OK] button to close System Properties, and then click
"X" in the upper right of the window to close the Control Panel.
5 Insert the included CD-ROM into the CD-ROM drive.
6 Make sure the POWER switch on the Clavinova is set to OFF and
use the USB cable to connect the USB terminal of the computer
(or the USB hub) to the USB terminal of the Clavinova. When the
Clavinova is turned on, the computer automatically displays the
"Found New Hardware Wizard."
7 Check the radio button to the left of "Search for a suitable driver
for my device. (Recommended)." Click [Next].
The system starts the installation.
8 When the installation is complete, the system displays "Complet-
ing the Found New Hardware Wizard." Click [Finish].
n Some computers may take about ten seconds to show this screen
after the installation is complete.
9 Restart the computer.
The driver has been installed.
Serial Driver
1 Double-click on the "Mididrv_" folder.
"Setup.exe" file will be displayed.
2 Double-click on the "Setup.exe" file.
When the setup has been initialized, the "Welcome" window will
appear.
3 Click [Next].
The "Select operation" window will appear.
4 Click the radio button to the left of "Install YAMAHA CBX
Driver."
Click [Next].
5 The license agreement for the YAMAHA CBX Driver will be dis-
played. Please read it carefully.
6 Click [Yes].
The "Select COM port" window will appear.
7