Procedure For Applying A Correction Value; Correction Value - Lapierre LB User Manual

SECTION 3 Start-up and operating procedures (continued)
3.6.1

Procedure for applying a correction value

To subtract or add a correction value to the actual value read by the In-Line Brix Meter, proceed as follows.
The concentrator must be in operation.
• Press the ZERO push-button (Illustration 1-c) continuously for a few seconds,
- the display shows "BRIX TUNING + the last value selected by the operator (+0.1 in our example)",
Illustration 12 | Correction value
• successively press and release the button,
- successively press and release the button to increase the correction value by 0.1 degree at a time,
- note that it is not possible to go backwards. To return to a previous value, press and release the button
successively until the desired correction value reappears in the increasing loop of proposed values,
• when the desired value appears on the display, press the button again for a few seconds,
• release the button when the display shows "TUNING COMPLETED".
Note that if you do not press the button for 30 seconds, you will return to the Brix reading screen.
Lapierre Equipment | 0-45 DEGREE IN-LINE BRIX METER | USER MANUAL | Version 01 - February 2024
11