Lubrication Guide - International Harvester Company 75 Operator's Manual

LUBRICATION GUIDE
Afer Every 10 Hours of Operation -Continued
Use IH 251 H EP grease or equivalent No.2 multi-purpose
lithium grease and apply one or two strokes of the lubricator to
the grease fittings (one fitting on each front wheel).
6.
Front Wheels
7.
Use IH 251 H EP grease or equivalent No.2 multi-purpose
lithium grease and apply one or two strokes of the lubricator to
the grease fittings (one fitting on each spindle). Center spindle
can be greased through lift handle slot.
Mower Spindle
Bearings (3)
Rear Discharge
Mower
See Page 15.
After Every 25 Hours of Operation
While the engine is warm remove the drain plug and drain all the
oil from the crankcase. To drain completely, raise the right side
of the riding mower by placing a 4-inch to 6-inch block under the
right rear wheel. After draining, replace the drain plug. Remove
the crankcase oil filler cap and refill the crankcase with new oil
up to the "FU LL" mark on the oil level gauge. Refer to the
"Lubrication Table" for proper quantity and viscosity to use.
8.
Engine Crankcase
See Page 13.
9.
Use IH 251H EP grease or equivalent No.2 multi-purpose
, lithium grease and apply one or two strokes of the lubricator to
the grease fittings (one fitting on each spindle). Center spindle
, can be greased through lift handle slot.
Mower Spindle
Bearings (3)
Side Discharge
Mower
See Page 15.
Check
at
Hours
Change
at
Hours
Anticipated Air Temperature
Point of Lubrication
Above
+320 F.
+320 to 00 F. Below 00 F.
I. H. No.1 @
Engine Oil
SAE-30
I.H. No.1 (!)
Engine Oil
SAE-10W
SAE-5Wor
SAE-5W-20
32 oz.
Engine
Crankcase 5
25
1
qt.
Transmission and
Differential
Factory sealed. See your ,. H. Dealer
22-