Cub Cadet 6284 Operator's Manual page 13

FENDER MOUNTED CONRTOLS AND FEATURES
H
J
A. Fuel Fill Cap
The fuel fill cap is located on the left fender beside
the operator's seat.
WARNING: Never fill the fuel tank to
the top of the filler neck. Expansion
could result in overflow, allowing
highly flammable fuel to come in
contact with the operator.
B. PTO Reverse Override Switch
The PTO reverse override switch is located on the
left fender. Depress the front of the switch to
engage the override which allows the PTO to oper-
ate while the tractor is traveling in the reverse
direction. The indicator light in the overide switch
will illuminate when the switch is depressed to the
"ENGAGED" position. Once activated, this func-
tion remains activated until the ignition switch
is turned to the OFF position.
WARNING:
when operating PTO driven attach-
ments while traveling in the reverse
direction.
B
A
C
G
A Fuel Fill Cap
B PTO Reverse Override Switch
C PTO Selection Lever
D Hydraulic Lift Lever
E Trans. Hi/Lo Shift Lever
F Cup Holder
G Hand Holds
Use EXTREME caution
N
D
M
K
Figure 11
H Amber Hazard Lights
J Tail Lights (Red)
K Storage Tray
L Foldable ROPS
M Seat Belt
N Auxiliary Hydraulic Control Handle
C. PTO Selection Lever
The PTO selection lever is located on the left
fender. Pull the lever to the right side of the slot to
clear the shift gate, then shift the lever as follows:
• Push the lever forward to engage the mid PTO.
• Push the lever rearward to engage the rear
PTO.
• Move the lever to the center position to
simultaneously engage both the rear PTO and
mid PTO.
D. Hydraulic Lift Lever w/Position Control
The hydraulic lift lever is located on the right fender.
This lever controls the position of the three point
hitch lift arms. There is a direct relationship
between the position of the lever and the height
position of the installed equipment.
• To lower the lift arms, move the lift lever
forward until the desired height setting is
attained.
• To raise the lift arms, move the lift lever
rearward until the desired height setting is
attained.
13
E
G
F
L
H
J