•
Maintain the weight balance of the tractor.
Install front end weights to counterbalance
heavy implements attached to the three point
hitch. Do not operate the tractor with a light
front end.
•
Any towed vehicle with a total weight exceeding
that of the tractor should be equipped its own
braking system that is operational from the
tractor seat.
•
Do not leave equipment in the raised position.
•
Watch for traffic when operating near or
crossing roadways. If local laws permit road
travel, use the flashing hazard lights and SMV
signs when traveling on public roadways.
•
Make certain all tractor lights are illuminated
when operating at night.
•
Always watch where you are going, especially
at blind corners, trees, or other objects that can
obscure your vision.
•
Check overhead clearance carefully before
driving under power lines, wires, bridges or low
hanging tree branches, before entering or
leaving buildings, or in any other situation
where the operator and/or roll bar may be
struck, which could result in serious injury.
•
To avoid upsets, drive the tractor with care and
at a safe speed. Use extra caution when
operating over rough ground, when crossing
ditches or slopes, and when turning corners.
•
If the tractor becomes stuck, use reverse to
free the tractor to prevent tractor upset.
2. SLOPE OPERATION
Slopes are a major factor related to loss of control
and tip-over accidents which can result in severe
injury or death. All slopes require extra caution. If
you cannot back up the slope or if you feel uneasy
on it, do not operate this unit on that area or serious
injury could result.
DO:
•
Operate up and down slopes, not across.
•
Remove obstacles such as rocks, limbs, etc.
•
Watch for holes, ruts or bumps. Uneven terrain
could overturn the machine. Tall grass can hide
such obstacles.
•
Place the transmission in the low range. when
climbing or descending slopes. Always keep
machine in gear when going down slopes to
take advantage of engine braking action.
•
Follow the manufacturers recommendations for
counterweights to improve stability.