Related Manuals for Gorenje IHT941A2XBG
Summary of Contents for Gorenje IHT941A2XBG
- Page 1 IHT941A2XBG / E100EI1S40BF4EASCB IHT971S2XBG / A100EI1SB35BH2SEASCB IHT961S2X / E100EI1S40BF4EASCB www.gorenje.com www.gorenje.com...
-
Page 10: Cooker Hood
COOKER HOOD Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. The hood is conceived for the suction of cooking fumes and steam and is destined only for domestic use. -
Page 11: Ducting Version
The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further detailed information regarding the process, collection and recycling of this product, please contact the appropriate department of your local authorities or the local department for household waste or the shop where you purchased this product. -
Page 12: Installation
INSTALLATION The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. Electrical connection The mains power supply must correspond to the rating indicated on the plate situated inside the hood. -
Page 13: Operation
OPERATION Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. - Page 14 With the display on (ON) and the suction off (OFF), press simultaneously the buttons T8 and T9 for more than 3 seconds; the button T9 lights on with steady light for approx. 5 seconds, to indicate the activation. To disable it, repeat the operation; the button T9 will flash for approx. 5 seconds to indicate the disabling. Setting of Automatic Operation parameters For correct use of the automatic operation, perform "Hood Calibration"...
- Page 15 IHT941A2XBG To select the functions of the hood, simply touch the controls. T1. Standby mode (the control panel off ! all functions disabled) / ON (control panel switched on) Note: After about a minute of inactivity (suction and lights), the hood will automatically switch to standby.
- Page 16 Hood Calibration With the display on (ON) and the suction off (OFF), press button T4 for 5 seconds. The suction speed (power) 2 starts functioning and button T4 flashes to indicate that hood calibration is initiated and it will last for approx. 15 minutes. Note: to interrupt the calibration, press T4 for 5 seconds;...
-
Page 17: Maintenance
MAINTENANCE ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Cleaning The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally.
Need help?
Do you have a question about the IHT941A2XBG and is the answer not in the manual?
Questions and answers