Table of Contents
Advertisement
competent person following the fitting instructions provided by the plug manufacturer.
Please note the following:
1)
Ensure that the lengths of wire to be fitted inside the plug have been cut to the correct
length and the end correctly prepared. When preparing the cable ends take care not
to damage the outer sheath, or the insulation surrounding the inner conductors.
2)
Connect the blue (NEUTRAL) wire to the terminal in the plug which is marked with the
letter "N" or coloured black.
3)
Connect the brown (LIVE) wire to the terminal in the plug which is marked with the
letter "L" or coloured red.
4)
Connect the green/yellow (EARTH) wire to the terminal in the plug which is marked
with the letter "E" or coloured green.
5)
Tighten all screws. Ensure that all conductor strands have entered into the terminal
posts and that the mains lead is securely held in place by the cable clamp.
Motor
110 volt models are rated at 0.9kw in accordance with BSEN60335-2-69 230 volt models
are rated at 1.0kw in accordance with BSEN 60335-2-69.
The motor used in this appliance is a non-sparking electronically commutated brushless
motor and consumes a maximum running current of 9 amps (230v models) and 13 amps
(110v models). The electrical supply should be fitted with a fuse/protective device
suitable for the current demand.
The electronic control of the motor limits the starting current to the above values. The
motor is thermally protected. There is a thermal switch to protect the windings in the
motor and there is a thermal switch to protect the electronic control circuit board. If your
vacuum cleaner cuts out please refer to page 8 'Loss of Suction and Thermal Switch'. The
cut-out switches will automatically reset when the motor temperature drops.
6
Advertisement
Table of Contents
