Kenwood DNX7120 Instruction Manual page 102

Use of c ontrols or a djustments or performance ofprocedures other than those specified herein may result inhazardous radiation
exposure.
in compliance with F ederal Regulations, following are r eproductions of l abels on, or i nside the p roduct relating tolaser product
safety.
Kenwood Corporation
2967 3, ISHIKAWA MACHI,
HACHIOJI SHI
TOKYO, JAPAN
KENWOOD CORR CERTIFIES THIS EQUIPMENT 1
CONFORMSTO DHHS REGULATIONS N0.21 CFR
1040.10, CHAPTER 1, SUBCHAPTER J.
Location : Bottom Panel
FCCWARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the instruction ma nual, The user could lose the authority to
operate this equipment if an unauthorized change or modification is made.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation,
This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the
instructions, However, there is no guarantee that interference will not occur in a particular installation, If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures;
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radioFV technician for help.