Yaesu VR-120D Operating Manual page 34

Set Mode
Set Item 00 [STEP]
Function:
Available Values:
Default:
Set Item 01 [F STEP]
Function:
Available Values:
Default:
Set Item 02 [LAMP]
Function:
Available Values:
Default:
Set Item 03 [SAVE]
Function:
Available Values:
Default:
The VR-120D will be turned off for the interval programmed via this Menu item, then it
will check the current frequency for 250 ms, looking for activity.
Set Item 04 [OFFTIM]
Function:
Available Values:
Default:
Set Item 05 [PAUSE]
Function:
Available Values:
Default:
This Menu Item defines the length of time the scanner will hold on a frequency.
34
Channel Steps
AUTO / 5 / 6.25 / 9 / 10 / 12.5 / 15 / 20 / 25 / 30 / 50 / 100 kHz
AUTO
Selects the desired "Fast" Channel Steps
10 k / 100 k / 1M / 10 M / 100 MHz
1 MHz
Selects the LCD Lamp Mode
AUTO / ON /OFF
AUTO: Illuminates the LCD/Keypad lamp for 5 seconds when
any key is pressed.
ON: Pressing the LAMP key toggles LCD/Keypad lamp On/
Off.
OFF: Disables the LCD/Keypad lamp.
AUTO
Selects the Battery Save Interval ("sleep" ratio)
OFF / 1:4 (1 sec) / 1:12 (3 sec) / 1:20 (5 sec) / 1:28 (7 sec)
/ 1:36 (9 sec)
1:4 (1 sec)
Sets the "Sleep Timer" Time
OFF / 30 / 60 / 90 min.
OFF
Sets the Delay time for scanning
1sec ~ 12sec
5 sec
VR-120D O
PERATING
M
ANUAL