Yaesu FT-2000 Operating Manual page 14

B U
EFORE
Main ( VFO-A ) & Sub ( VFO-B ) Fields
These areas of the Display contain information about
the status of the Main (VFO-A) and Sub (VFO-B)
VFOs.
MODE Fields
These fields indicate the operating mode in use on
the above VFOs.
TX Frequency/Clarifier/
Antenna Selection Fields
These notations advise which VFO is being used for
transmission, status of the Clarifier, and a notation of
which antenna has been selected on that VFO.
Filter Fields
These fields note the offset status for the µ-Tuning or
VRF filters, as well as the Roofing filter selection,
for each VFO.
Filter Shift Fields
These fields graphically depict the positions of the
DSP RX filters for the Main and Sub VFOs, indicat-
ing any "IF Shift" or "Width" tuning changes applied.
Page 12
E
SING AN
A
BOUT THE
M
XTERNAL
M D
ONITOR ISPLAY
Bandwidth Fields
This field indicates the net receiver bandwidth cur-
rently set for the Main (VFO-A) and Sub (VFO-B)
VFOs.
Date Field
The current date is displayed here.
Local Time-1 Field
The current time at your location (Local Time-1) is
displayed here.
GPS Field
If you have connected an after-market GPS unit (one
providing NMEA location data) to the rear panel of
the transceiver, "
appear here. When display the your location on a
World Map with the GPS data, a base color of the
" " icon turns into yellow.
Local Time-2 Field
The Local Time-2 time, as programmed, will appear
here.
DMU-2000 D
ONITOR
" icon (Base color is white) will
M U