Table of Contents
Advertisement
Section 1
Quick Start
Overview
The quick start procedure is as follows:
1.
Read the Safety Notice and Precautions in section 2 of this manual.
2.
Mount the control. Refer to Section 3, "Physical Installation" procedure.
3.
Connect AC power. Refer to Section 3 "Control Installation".
4.
Connect the motor. Refer to Section 3, "Control Installation".
5.
Set the switches and adjust the potentiometers for desired operation.
See Figure 1-1.
The following procedure will help get your system up and running quickly, and
will allow you to prove the motor and control operation. This procedure
assumes that the control and motor are correctly installed.
WARNING:
Make sure that unexpected operation of the motor shaft during start
up will not cause injury to personnel or damage to equipment.
Power-up Procedure
1.
Open cover.
2.
Be sure all S1 switches are OFF.
3.
Rotate the % Speed control on the front panel to 0% speed (fully
counterclockwise position).
4.
Turn power on. Be sure the "Fault" LED is off.
5.
Press FWD. The LED on the FWD button should be on.
6.
Rotate the % Speed control to 30%. The motor should rotate in the
forward direction.
Note: If the motor rotates in the reverse direction, turn power off and
reverse any two of the three motor lead connections (J5-T1, T2 or T3).
Turn power on and start at step 3 again.
7.
Press STOP. The motor should decel to a stop and the LED on the
STOP button should be on.
8.
Press REV. The LED on the REV button should be on.
9.
Rotate the % Speed control to 30%. The motor should rotate in the
reverse direction.
10. Turn power off.
The control is now ready to be configured for your application and placed into
service. Refer to the appropriate connection diagram and setup procedure to
configure your system.
1-1 Quick Start
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
MN715P
Advertisement
Table of Contents
